CoolSoft VirtualMIDISynth oddity after upgrading to Version 2.75a.2

2017-10-15 04:43 am

Edited Post: I had noted that I ran into "port output fail" messages with CoolSoft VirtualMIDISynth (the program I use to avoid major latency issues) after upgrading to 2.75a.2 from nwc 2.75. Reinstalled NWC through 2.75 (testing at each iteration of NWC software) and problem went away. Could just be a minor glitch, and/or that my particular installation of NWC 2.75a.2 went strange, but thought I would mention it and potential fix in case folks run into similar issues with other auxiliary programs.

Re: CoolSoft VirtualMIDISynth oddity after upgrading to Version 2.75a.2

Reply #1 – 2017-10-16 09:45 pm

Upp. Problem cropped up again. This time, I uninstalled and reinstalled NWC through version 2.51. So far, so good. No pesky messages in regard to port failures. Will leave it at that for purposes of this forum unless problem rearises. However, if it is a glitch, probably something that should be looked at. Otherwise, NWC works splendedly.