Skip to main content
Topic: wrong repeat (Read 3387 times) previous topic - next topic

wrong repeat

I attached a portion of music by Tallis to show my problem.
From the "complete" file I took the last 5 measures of the S and A staves in which a repeat occurs.
I replaced the master repeat open bar way to the end to shorten the time you have to listen.
By coincidence I made apparently a correct tie in the S staff to the first note in the 2nd repeat; and this staff plays OK.
I tried to make the same tie in the A staff but after a lot of trials I gave up and you see the unchanged staff, which plays incorrectly.

Can somebody point me in the right direction?

Re: wrong repeat

Reply #1
You need to put the endings on every staff, even though they are only shown on the top staff.

When you put them on the "A" staff, you will see that they are automatically given a visibility of never by default.
Rich.

 

Re: wrong repeat

Reply #2
Thanks Rich; super fast! In fact quite logic!

Bram

Re: wrong repeat

Reply #3
You should also adjust the properties of the 1st ending's 2nd bar to:
"Continue prior ending"
and
"Closed ending."

Also:
remove the
"closed ending" in front of the 2nd ending,
as shown in
"Piece_adjusted.nwc