Skip to main content ↑ ↓
Topic: It ignores my coda! (Read 6575 times) previous topic - next topic

It ignores my coda!

I put in a D.S. al Coda in measure 39 to go back to measure 6, where I stuck the Segno.  The "To Coda" is at measure 16.  I then stuck the Coda ending directly next to the D.S. al Coda, with a double bar line in between.  When I tell it to play back, it goes back to the Segno, but plays the Coda at the same time.  How do I fix this?

Re: It ignores my coda!

Reply #1 –
Nevermind, I figured it out:
The flow direction signs were only on one staff.  They needed to be on all of them.

Re: It ignores my coda!

Reply #2 –
FWIW, putting them on all the staffs makes for a cluttered score when printing.  Set the visibility option to On Top Staff to correct that.  Then if you're printing single instrument parts they'll show, but if you're printing a score or a piano part, you'll only see them on the top line.