Skip to main content
Topic: problem pre-viewing a print and printing on demo of 1.31 (Read 6915 times) previous topic - next topic

problem pre-viewing a print and printing on demo of 1.31

i installed the 1.31 version from this sight as a demo and can not get it to preview and print properly nor print properly. Is this a restriction in the demo or a installation problem?

Does anyone else out there want NW to add tablature? It would be of great benifit ... as of now I am needing to cut and paste in a graphics program to print what I need ... and this is keeping me from buying much of any program.

Re: problem pre-viewing a print and printing on demo of 1.31

Reply #1
Gary, you'll have to provide some more details.

You said <<<i installed the 1.31 version from this sight as a demo and can not get it to preview and print properly nor print properly. Is this a restriction in the demo or a installation problem?>>>

It always previewed and printed properly for me, even as a demo. Check that your printer setup and page setup look sensible (abot 12 points for print-outs looks good).

More than that I can't say without more info.

Regards,

Andrew mailto:apurdam@pcug.org.au

Re: problem pre-viewing a print and printing on demo of 1.31

Reply #2
This would be an awsome program if only it had tablature!!