Launching a File from NWC 2 Viewer 2006-10-27 09:26 pm I was reading a message on the newsgroup and launched the attached file. It launched into the NWC 2 viewer. If I click on the button to load it into NWC2, I get the following error message:"The Windows shell reports that the file could not be opened using the "Open with NWC Version 2" verb. Is NWC 2 installed on your system correctly? Have you manually altered the file associations?"And then I get only an OK button to click (kind of weird response, since it's asking me two questions).Anyway, if I click on the NWC1 button, it launches fine into NWC2 (it was an NWC2 file). I have both NWC 1.75b and NWC Beta 2.06 installed on the computer.However, I tested this with both an NWC 1 and NWC 2 file. It only loads into NWC 2. I'm sure there's a problem with my setup, but it's weird that it always goes to version 2, but only when I click on the version 1 button. Quote Selected
Re: Launching a File from NWC 2 Viewer Reply #1 – 2006-10-28 12:11 am Uninstalling the viewer and reinstalling it from:http://www.noteworthysoftware.com/nwc2/viewer.htmshould solve your problem. Quote Selected
Re: Launching a File from NWC 2 Viewer Reply #2 – 2006-11-03 05:42 am If you have NWC1, NWC2, and the NWC Viewer installed, then you should have at least three actions associated with *.nwc files:OpenOpen with NWC Version 1Open with NWC Version 2If you have altered these actions, you can fix the first two by reinstalling the Viewer. In order to fix the last action, you have to reinstall NWC2. Quote Selected