How do I use my own controllers not pre-set in NWC?

2003-12-07 08:21 pm

I have an XG Sound card that comes with alot of controllers, but I'm not sure how to use these controllers in NWC.
Here is a list that shows different controllers available. NWC has pre-selected controllers for use by using "Insert>Multi-point Controller (L)"

I've noticed that in order to use these controllers, a "Voice Message/System Exclusive Message" must be used.
Shown here: http://nwc-scriptorium.org/helpful.html#GMCont
How do write a "Voice Message/System Exclusive Message" in NWC?

Thanks for your time, and if you do know how to do this, please be very descriptive, so that I may understand the instructions clearly.
Thanks again,
-Joel

Re: How do I use my own controllers not pre-set in NWC?

Reply #1 – 2003-12-08 04:03 pm

In NWC, you can only use the controller that it supports. These are shown in the MPC properties. NWC does not currently support System Exclusive messages.

Re: How do I use my own controllers not pre-set in NWC?

Reply #2 – 2003-12-08 05:51 pm

Will this be included in future versions?
If not, you'll lose this customer.
Thanks again.
-J