My bad memory!
Which was the trick to have the dynamic variance during trill, tremolo or arpeggio?
Beside the multipoint controller, of course.
I'm sure I saw it.
!NoteWorthyComposerClip(2.75,Single)
|Dynamic|Style:f|Pos:-9.5|Wide:Y
|RestChord|Dur:Half|Opts:Stem=Down,Diminuendo,ArticulationsOnStem,Muted,HideRest|Dur2:Whole|Pos2:10
|User|Tremolo.ms|Pos:1
|RestChord|Dur:Half|Opts:Stem=Down,Diminuendo,ArticulationsOnStem,Muted,HideRest|Dur2:Whole|Pos2:b11
|Bar
|Dynamic|Style:pp|Pos:-10|Wide:Y
!NoteWorthyComposerClip-End
!NoteWorthyComposerClip(2.75,Single)
|Dynamic|Style:f|Opts:Velocity=127,Volume=92|Pos:-9.5|Wide:Y
|RestChord|Dur:Half|Opts:Stem=Down,Diminuendo,ArticulationsOnStem,Muted,HideRest|Dur2:Whole|Pos2:10
|User|Tremolo.ms|Pos:1
|RestChord|Dur:Half|Opts:Stem=Down,Diminuendo,ArticulationsOnStem,Muted,HideRest|Dur2:Whole|Pos2:b11
|Bar
|Dynamic|Style:pp|Opts:Velocity=127,Volume=30|Pos:-10|Wide:Y
!NoteWorthyComposerClip-End
You have to edit the properties of the dynamics : set 'Change Channel Volume' to the value of 'Custom Note Velocity'. (Don't forget to check the 2nd box).
!NoteWorthyComposerClip(2.75,Single)
|Dynamic|Style:f|Opts:Volume=92|Pos:-9.5|Wide:Y
|RestChord|Dur:Half|Opts:Stem=Down,Diminuendo,ArticulationsOnStem,Muted,HideRest|Dur2:Whole|Pos2:10
|User|Tremolo.ms|Pos:1
|RestChord|Dur:Half|Opts:Stem=Down,Diminuendo,ArticulationsOnStem,Muted,HideRest|Dur2:Whole|Pos2:b11
|Bar
|Dynamic|Style:pp|Opts:Volume=30|Pos:-10|Wide:Y
!NoteWorthyComposerClip-End
You were a little faster, Rick! ;)
A-ha!
So the trick is indeed to fiddle with the volume, but simply using dynamic's "advanced user settings" instead of a multi-point controller.
At least, in this case there is no need to guess a sweep resolution. :D
Thanks.
In this case, NWC puts in 64 MIDI volume messages. If you want fewer, use an MPC