Skip to main content ↑ ↓

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - VolcanoUSA

1
General Discussion / Re: maybe it's a midi problem?
I have put in a little time on this.  For anyone else following this, the recommended bank for Jeux is #42.  I moved everything accordingly, but this did not help.  What has helped is to send a midi at the end of each stave, as in Patch 1, Bank 0, making sure to check "Send Bank Select", then to add an MPC setting the volume to 1, and adding a single note.  I tried a variety of using these singly or in pairs, instead of all three, but that did not work for me.

So, the wedding may proceed as planned ;)

Thanks for being here!

Judy

2
General Discussion / Re: maybe it's a midi problem?
Thanks guys!

I'm in the process of sorting out which fonts are used where.  I see in the scriptorium that there are new versions of AWE and JEUX fonts, so I'll be giving those a try, but since JEUX is recommended to be on bank #43+? and I've had it on #2+, I thought I'd go through it and see if that doesn't give better font management.

Nice to see you again Rich! :)

Judy
3
General Discussion / maybe it's a midi problem?
Hello (again).

After long absence, I'm attempting to use NWC again, so I'm a bit rusty.  I have a song from an older version, and I may have had this problem on the older version, I don't remember. 

My song has lot of MPC's in it, it also uses organ sound fonts.  On a 'fresh' start, opening NWC, loading the song and playing it, the play is perfect.  But on replay, the sound is off by at least one octave too high.  The only way I have found to get it to play correctly again is to close NWC, and start over.  So I think I must be missing some sort of 'reset', but after quite a lot of searching, haven't been able to find just what.

I've read some of this forum and tried to search for this problem but no joy.  I did try the suggestion to add a bar at the end with 'Force System Break' also no joy.  I have narrowed it down to one single register, but still have the problem.

Help?

Many thanks, and many thanks to those that have kept these forums going!

Judy