Skip to main content

Topic: Layering not available? (Read 2065 times) previous topic - next topic

Layering not available?
I'm sure this is something easy. I had an existing SATB piece with 4 separate staves. I added a fifth staff for S2, moved it below the first staff, went to the first staff, and tried to layer it, but "Layer with next staff" is greyed out. Why would that be?

Re: Layering not available?
Reply #1
See: Page Setup Command
Quote from: http://www.noteworthysoftware.com/nwc2/help/MNU_PAGESETUP.htm
Allow Layering
This enables layering of parts within the file. If this is turned off, then no layering will be done for this file, and the other layering options will be unavailable.
Registered user since 1996

Re: Layering not available?
Reply #2
I knew it was easy. Thanks. I can't believe I got a reply so quickly.