Skip to main content

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - Marcia

3
General Discussion / Re: Last Measure
Thanks Rich.  I guess I didn't understand. 

Do you know if there's a way to force a page break when printing?

Thanks again.

Marcia
4
General Discussion / Re: Last Measure
Rich,

Thanks for your help.  It turns out that my problem was not with checking "extended systems" (I had that turned off) but with the little paragraph-like mark which is sometimes attached to a decorated bar line.  I convert most of my files from abc and so it's not something I put in myself -  at least not intentionally - and I never knew what it was for.

I just now discovered that the puzzling little mark is inserted when you check "force system break" in the decorated bar line pop-up menu. It causes the last line to extend regardless of what's in the page setup.  When I deleted the bar line and re-inserted it without the "force system break", the problem went away.

I initially thought that "force system break" would solve the problem, not cause it, but that doesn't seem to be the case.

Marcia
5
General Discussion / Last Measure
When I print a tune I want the length of the last measure to be the same as it would be if it were anywhere else in the piece.  Instead, NWC extends it so it reaches the right margin.  Does anyone know a way to fix this?  I'm in 2.5.4.

Thanks.