NoteWorthy Composer Forum

Forums => General Discussion => Topic started by: FrankSit on 2022-11-08 12:57 am

Title: Tenor & Bass Lysric
Post by: FrankSit on 2022-11-08 12:57 am
Hello,

Can anybody help me how to make the part of the lyrics of bass and tenor, look like the attached?. I want to put all verses lyrics in each staff, Soparano, Alto Tenor and Bass, and when I layer it, I want it looks like the song sheets attached. But also I have a problem now, I do not know why I can not layer it.

Thank you

Frank
Title: Re: Tenor & Bass Lysric
Post by: David Palmquist on 2022-11-08 01:33 am
I don't work with lyrics, but:

You can create your four lines of lyrics in one staff using Lyric 1, Lyric 2, Lyric 3 and Lyric 4 tabs in the Lyrics menu.  This may cause problems if the words begin with note changes that differ in that part (i.e. trebles' words may not begin at the same beat as the bass lyrics.).

In that case create a separate lyric for each staff and place them below the treble staffs (Lyric 1, Lyric 2) or above the bass staffs ( Lyric 3,  Lyric 4).   I think you simply position them above or below the relevent staff using the Configuration tab in the Lyrics menu and maybe use the Offset settings to adjust their height.

Title: Re: Tenor & Bass Lysric
Post by: FrankSit on 2022-11-08 02:44 am
[You can create your four lines of lyrics in one staff using Lyric 1, Lyric 2, Lyric 3 and Lyric 4 tabs in the Lyrics menu.  This may cause problems if the words begin with note changes that differ in that part (i.e. trebles' words may not begin at the same beat as the bass lyrics.).

Thank you David, that is what I did. and looks ok.

Frank